The RTP Pager can receive G.711-encoded audio data from up to four multicast groups (i.e., combinations of IP addresses and ports).
The received data will be played on the camera speaker. As a precondition, the camera must have a speaker connected that has to be activated. (see Speaker and Microphone dialog).
Note that the received audio data will not be mixed. If data are received from different multicast groups, the first group to send its data will be played on the speaker. If this group stops the transmission, the next group will be played automatically.
Note that in one multicast group, only one sender may send data at any given time! If several services send audio data at the same time to the same multicast group, the audio data cannot be played properly.
Activates the RTP Multicast Pager ("RTP Pager"). Changes require rebooting the camera.
Every one of the four streams has its own configuration section with the corresponding parameters Multicast IP and Port.
IP address of the multicast group sending the audio data. The IP address must be a valid multicast IP in the range from 224.0.0.0
to 239.255.255.255
.
Network port used to receive the multicast data. The port has to be in the range from 1025
to 65535
. A value of 0
will deactivate the receiver.
設定 ボタンをクリックすると、次にカメラが再起動するまでの間、設定内容が保存され有効になります。
出荷時設定 ボタンをクリックして、このダイアログに工場出荷時設定値をロードします (このボタンはすべてのダイアログにはありません)。
リストア ボタンをクリックすると、カメラに永久保存される前の直近の変更が元に戻ります。
閉じる ボタンをクリックするとダイアログが終了します。ダイアログを終了している間、システムは設定全体に変更があるかどうか確認をします。設定に変更が検出されると、システム設定値を永久に保存するかどうか確認されます。